![]() Consider the environment around the device.To ensure that the FRL unit, or one of its components, meets the pressure ranges in and out of the flow rate requirement (typically in liters per min), consult the datasheet for the specific unit. if any air quality standards apply to the workplace.air quality requirements of the tools using compressed air.Before selecting an FRL unit, it is important to consider a few system parameters:.Give careful consideration to the order and location of these devices. As a general rule, a pneumatic system’s order of installment is: a compressor, filter, regulator, and lubricator. If a tool isn’t self-lubricating, also install a lubricator in the system. Most modern pneumatic tools use self-lubricating seals, and the user often does not need to install a separate lubricator. However, ensure that every air system uses at least one filter and one pressure regulator. The FRL components necessary depends on the system requirements. It is essential to understand the air requirements of the system and components to determine the selection of individual components of an FRL unit for an application. Install an air compressor filter and regulator unit if the equipment is self-lubricating and an FRL unit if the equipment requires lubrication. This is often done last and/or right before the component that needs lubrication.įilter, regulator, and lubricators are available individually or as a combined air filter-regulator (FR) or filter-regulator-lubricator (FRL) unit. Lubricators: Lubricators reduce the internal friction in air tools by releasing a controlled oil mist into the compressed air.Regulators adjust and control the air pressure of a system to ensure that down-line components do not exceed their maximum operating pressures. ![]() Regulators: The second step in an FRL system is a regulator.Filters: Filters remove water, dirt, and other harmful debris from an air system, which is often the first step in improving air quality.The three components in an FRL unit work together. A proper air filter, regulator, and lubricator unit in a pneumatic system provides higher reliability of the components downstream, reduced power wastage from over-pressurization, and increased component lifetime. It is also possible to use each component individually. ![]() These individual units can combine into one unit to ensure clean air in a pneumatic system. View our online selection of filters, regulators & lubricators!Īn FRL unit comprises a filter (F), regulator (R), and lubricator (L).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |